Security Perth Agility 3 Bedienungsanleitung PDF herunterladen (Seite 42)

Agility 3 User Manual

Page 42

Code

Status LED/Buzzer Indications

After each transmission (indicated by a flashing Green LED) from the remote control, the

Agility sends a status response indicated by the remote control's LEDs and Buzzer:

LED Indications

Operation

1st LED *

(Send

command)

2nd LED

(Receive

Status)

Away Arm

Green

Red

Stay Arm

Green

Orange

Disarm

Green

Alarm

Green

Flash Red LED

*If the 1st LED changes to orange it indicates a low battery condition.

Buzzer Indications

Sound

Status

1 beep

Confirmation

3 beeps

Error

5 beeps

Alarm

Changing Remote Control PIN Code

Each remote control can be defined by your installer to be activated with a unique PIN

code.

To change the remote control PIN code (from the remote control itself):

Note: To change the PIN code it is mandatory to perform the following procedure in close

proximity to the control panel.

Press the +

4\?

simultaneously for 2 seconds.

Enter the remote control current 4 digit PIN code.

Press followed by a new 4 digit code.

Press .

The panel will send a confirmation message. The remote control will sound a long beep

and the Green LED will turn on. If no confirmation sound is heard the old PIN code will

remain. Repeat the procedure again to replace to a new code.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Security Perth Agility 3 Bedienungsanleitung Seite 42

Kommentare zu diesen Handbüchern